http://www.pwcforum.com
 
Go Back   PWC Forum: The best hang-out for Personal WaterCraft enthusiasts


» Sponsors





» Sponsors
View Single Post
Old 07-05-2009, 07:14 PM   #8 (permalink)
GCwaverunner
Senior Member
 
Join Date: Jun 2009
Location: Australia
Posts: 323
Default

generally a carb issue wont restrict top end speed. However, carbs will effect take off. I would recommend pulling the carbs off and giving them a good clean out (fuel pumps on each carb) to eliminate this take off potential problem. Its good to do the carbs anyway to see what condition theyre in. When you are pulling the carbs off, you will have to pull the echaust off which means you can physically look inside the rear exhaust and check that the cat/convertor is still intact. If not, replace with d plate and sensor cut off. Parts of the cat/con can get caught in the exhaust causing performance problems. Also, check the condition of your impeller for any dents etc and the liner gap should be under 1mm. All these things would pretty much ensure you have checked eveything.
GCwaverunner is offline   Reply With Quote
 
Powered by vBadvanced CMPS v3.2.2

All times are GMT -5. The time now is 09:11 AM.