Yamaha GP1200 dash buttons. - PWC Forum: The best hang-out for Personal WaterCraft enthusiasts
http://www.pwcforum.com
 
Go Back   PWC Forum: The best hang-out for Personal WaterCraft enthusiasts > PWC Jetski Specific Forums > Yamaha Jetski


» Sponsors





Reply
 
LinkBack Thread Tools Display Modes
Old 09-24-2009, 06:28 AM   #1 (permalink)
Junior Member
 
Join Date: Sep 2009
Location: Australia
Posts: 3
Default Yamaha GP1200 dash buttons.

Hi all, just bought a 1999 GP1200. It has a security code on the dash via 3 buttons A.B.and C. Can anyone tell me how this works and can I change the code. I am also looking for a workshop manual for this ski, where can I get one.
infidel is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 09-24-2009, 11:37 PM   #2 (permalink)
Senior Member
 
Join Date: Dec 2007
Posts: 227
Default

Try ABCA, then try AAAA, BBBB, CCCC. One will work. Not sure how to change them.
fedorov5549 is offline   Reply With Quote
Old 09-27-2009, 09:42 AM   #3 (permalink)
Junior Member
 
Join Date: Jul 2009
Posts: 5
Default

Under front hatch and bucket covers find a blue wire connector and disconnect,reset code to what you want (four letters) then reconnect blue wire.
glenn briglio is offline   Reply With Quote
Old 10-05-2009, 08:22 PM   #4 (permalink)
Junior Member
 
Join Date: Aug 2009
Posts: 11
Default Get a manual here

Honda Odyssey FL250 MANUAL , FL350 , FL400 , Honda FL 250 , Honda Pilot FL400 , Kawasaki Mule , Honda Odyssey , ATC , TRX , FOURTRAX , Sea Doo , FL 400 , Workshop Work shop MANUAL Honda FL250, Kawasaki Jet Ski , Seadoo , tech , 4tech , 4-tech , Polar

It's been a long time since I did it but, I also think you can reset the code by disconnecting the blue one-pin coupler (that goes into the display unit), pressing mode for 3 seconds, and keying in the new 4-digit code. A blinking 'set' should then be displayed. The buzzer should sound and 'START' should be displayed. After it clears, re-connect the blue coupler and you should be good to go. Test by holding down the mode button for 3 seconds, keying in new code, and it should toggle between "start" and "locked". I also think this procedure is laid out in the Owners Manual.
bigair64 is offline   Reply With Quote
Sponsored Links
Advertisement
 
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Powered by vBadvanced CMPS v3.2.2

All times are GMT -5. The time now is 12:18 AM.




SEO by vBSEO 3.6.0