Personal Water Craft Forum banner

Search results

1-8 of 8 Results
Advanced Search
  1. Bogging while turning

    General PWC & Jetski Discussion
    Thanks to everyone for the help. What keeps the tank from over pressuring? I assume return lines in carb are clear because while pressuring up for pop off valve test, I had flow out of the return lines(but will check when I tear down, I am ordering carb rebuild kits again before tearing in to...
  2. Bogging while turning

    General PWC & Jetski Discussion
    ok checked pop off pressure, Hand pump i have is extremely accurate and i plugged the return line and as i was pumping (pump has mineral oil in it gauge is digital) it drifts down very quickly and i cant really get the pressure up high enough to lift until it gets to like 190lbs. I called a...
  3. Bogging while turning

    General PWC & Jetski Discussion
    Rodsatheart, Thanks for the confidence builder, changed plugs fuel filter and tank vent, it is oriented correctly, no change. pulled exhaust and borrowed digital hand pump from work to check pop off pressure. What number am I looking for? Slowly pressured up the supply line on each carb and and...
  4. Bogging while turning

    General PWC & Jetski Discussion
    Update on bogging have not messed with ski in months completely lost interest, still cranked it up and ran it on hose periodically, drained gas and put fresh gas in it, checked compression again with known good Compression gauge and shows 140 on both Cylinders. ordered new plugs, and oil block...
  5. Bogging while turning

    General PWC & Jetski Discussion
    Changed accelerator pump made sure nozzles and hoses were all clean and clear. Installed new plugs. verified low speed and high speed needles are 1/2 and 2 on both carbs. Jet ski ran fine for about 20 seconds then started bogging again. pulled plugs and no oil and not wet at all. Anyone in the...
  6. Bogging while turning

    General PWC & Jetski Discussion
    High and low speed jets were put back exactly and the nozzles were clean I will order diaphram. So should I change springs on needle inside carb while I have it Apart? Thanks for the help
  7. Bogging while turning

    General PWC & Jetski Discussion
    anyone have any ideas on what the problem is and what does the small pump on top of the front carb do?
  8. Bogging while turning

    General PWC & Jetski Discussion
    New to forum today...2003 Xlt 800 from slow idle Bogging bad while turning and slight hesitation going straight from dead stop. Changed plugs first, Rebuilt carbs still having the problem. Runs great all other times compression is about 100 on both cylinders, also drained all gas during carb...
1-8 of 8 Results
Top