Personal Water Craft Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Yamaha Jetski
    I have an '03 Yamaha 1200XLT that has been really reliable for 18 years, but now needs some maintenance. I get the exhaust warning that I've seen many people report and it runs a little rough (though it still develops full power). I took it in for diagnostics and wasn't too surprised by the...
  2. Aftermarket Performance
    I am new to jet ski, but have been boating for years. I have a 1996 Yamaha Wave Raider 1100 and need to rebuild the stock carbs. Yamaha said the OEM parts are no longer available. Where do you all get your parts from? Thanks in advance.
  3. Sea-Doo Jetski
    I have a 1996 Seadoo GTX that I have been rebuilding. I swapped the motor from a wrecked hull into a good hull. When I first started the project and I did a compression test and got about 160 on each cylinder. When I got to the point of starting the ski I had no fuel pressure. I thought that my...
  4. New Member Introductions
    I am here becuase i purchased a ts650 yamaha 1992, everything in it looks very well, and starts and runs when prime, but a minute later dies, and would not restart, unless a prime it again, i have change the carb seals and clean it, unfoutunately i did not do the ultrasonic clean, but the seals...
  5. Yamaha Jetski
    Good day, just acquired new to me 05 gp800r and 05 xlt1200 from a friend who wanted them gone. both with bad top ends. My first two PWC ever, and I'm pushing 50. I'm pretty handy, but no mechanic. Disassembly went very well, straightforward. found problems with low compression. maybe this...
1-5 of 5 Results