Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,032 Posts
If the engine will run on the hose (no load system), but not in the water (under load), it usually means a kaput cylinder. I'll be totally surprised if you don't find low compression in 1 or both cylinders (I'm guessing the normal value should be around 140-150 psi and both cylinders should be within 5 psi).
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top