Personal Water Craft Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey everyone,

Hoping someone might be able to push me in the right direction regarding a problem I'm having with my WR 500. After finally getting the thing to run yesterday, I ran and flushed it for about 10 minutes, following the proper procedures (turning the water off before shutting the engine, throttling up the engine after water disconnect).

When I went to go put it back in the garage, I gave it another test to see if it'd start up again. I held the starter and nothing. No noise from the starter motor, no cranking, 0. Complete silence. I tested the battery and it's fully charged.

I'm not sure if running it triggered the issue, but does anyone have an idea as to what may be wrong?
 
1 - 1 of 1 Posts
Top