Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I need to take off the drive gears on both the impellar shaft and the engine crankshaft. I removed the impellar shaft gear, but the crankshaft drive gear will not move. I would like to know if the gear is regular thread like the impellar gear or is it reverse thread. The crankshaft moves when I try to spin the gear off. Need some good advice please.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.