Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi I have a 1993 Vxr pro that I just rebuilt the pump on, however when I went to reinstall the pump the bolt holes don’t line up and the pump won’t seat. I feel the splines go into place but it is still off by about two inches. Any reason why it’s not seating?
image.jpg
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
Finally got it in the splines weren’t lining up so I had to loosen the intermediate shaft to get the splines to go in. But all good now.
 
1 - 3 of 3 Posts
Top