Personal Water Craft Forum banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hello everybody!

Just took out the jetski out onto the lake after installing a new MicroTouch rev limiter. The seadoo ran great except for the gas gauge flashing to full and all the lights on the gauge flashing only when I gave full throttle. After about 15 minutes of driving it, the problem seems to go away. Another fifteen minutes of riding and both the speedometer and the gas gauge stop working altogether. Still works fine apart from that as well.

Back at the house I check out all the wires to and from the electronics box and to the gauges, nothing fishy as far as I can tell. I even disconnect the MicroTouch rev limiter from the MPEM and still the same problem. The GTX starts up and runs great, only the gauges aren't doing anything.

Any help would be greatly appreciated!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.