Personal Water Craft Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Are you talking about the insert inside the hull or the plastic piece under the ski?
 

·
Registered
Joined
·
48 Posts
This would be the plastic piece inside the hull. It actually has a lip inside the hull and goes through to the underside by the pump. The bearing carrier connects to it inside the hull. Basically it looks like a round piece of PVC pipe.
I usually cut them out and epoxy the new BRASS one back in with two part epoxy.
 

·
Registered
Joined
·
48 Posts
Sorry Jay, didnt see your question earlier, but you did it right. Congrats!!! I should have been clearer, what I meant by cut out the old one is, cut the old one flush with the hull.
 
1 - 3 of 3 Posts
Top