Personal Water Craft Forum banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
just picked up 2 1996 650cc yamaha jet skis that have not been run in 3 years. Do not know any other history. Have cleaned them up and pulled one of the enginesand drive train. Engine truns smooth but top of cylinder heads are rusty. Drive train will not turn.

Would like to hear thoughs on re-build of engine and drive train.

Where is best place for parts. How far do you go into engine beyond rebulding carb, replacing rubber tubing and replacing gas?

Shoud electricl be replaced? Reeds? What is typically re-built.

Starting a new adventure!!!!!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.