Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
When trying to rev the engine it seems to hit around 2500 to 3000 and then stop as if the rev limiter is cutting in. I have checked the oil level and temp and all seems fine. I have cut the spark leads back and I have had the carbs cleaned. Has anyone else experienced these kind of symtoms?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.