Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hey guys,
My ski is a Waveraider 760 that has been stalling when idling. I had looked at it and came to the conclusion that the carbs are not getting gas at low speeds. I put my hand over the carbs and it ran fine. I assume its a vacuum issue. The carbs were just rebuilt and to start the ski again after stalling I have to prime it every time. Does anyone have any solutions?
Thanks so much,
Stephen
 

·
Registered
Joined
·
12 Posts
Check the low and high mixture screws on each carb. Low should be 1 3/4 turns out, +/- 1/4 turn, high speed 1/2, +/- 1/4 turn. That's at sea level. Both carbs should be set the same. So when it's warm, it idles better with the choke on?

How do you prime it? Stock skis do not have a primer.
 
1 - 2 of 2 Posts
Top