Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
12 Posts
Check the low and high mixture screws on each carb. Low should be 1 3/4 turns out, +/- 1/4 turn, high speed 1/2, +/- 1/4 turn. That's at sea level. Both carbs should be set the same. So when it's warm, it idles better with the choke on?

How do you prime it? Stock skis do not have a primer.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.