Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I'm having a problem with my multi meter and need to know if anybody else had this problem, and if you did how did you fix it.

The meter turns on when i start the ski up but once i give it some gas the mph doesn't read just stays on 0. But when i open her up the meter shuts off completly until i get her down to a low speed basicly have to take my hand off the throtal. Any advice. Thanks Joe
 

·
Registered
Joined
·
10 Posts
Discussion Starter #2
Ok think i found out the problem. I was tracing out the speed sensor and my wire was cut. Now i'm looking for the a used speed sensor for this. New ones go for $145. Anybody know where i can get a used one? Thanks Joe
 
1 - 2 of 2 Posts
Top