Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Me too.

Sounds like the problem I'm having with my 95XP. Does yours run fine up to about 5,000 RPM if you just go easy on the throttle? Mine does about the same thing you described when I go full throttle. I emptied my gas tank, twice, put in new gas, changed plugs more than once. On mine this started after I had trouble with my exhaust pipe coming loose and spraying water all over inside. I'm wondering about the module or CDI, plug wires, or maybe the fuel pump or diaphram. Let me know if you get it figured out. Also you might have old gas, I'd siphon it out and then take out the tank completely and rinse it out with good gas. Remember to unhook battery first.

Good luck:thumbsup:
 

·
Registered
Joined
·
4 Posts
I got mine running good

Did you empty and rinse out the gas tank? Clean the fuel filter and filter bowl? Make sure no hoses are loose allowing water into tank.

I emptied my gas tank and put 4 gallons of BP Ultimate in, a pint of seafoam and about 3-4 ounces of Marvel Mystery oil. Ran for about 45 minutes as High RPM as it would run. Then shut it off for about 15 minutes. Next time I started it it ran full out at just over 7,000 RPM with no hesitation and has ran good since.

I also dried out all of my electrical connections, check the one coming from the magento. A Service Tech from a local dealer said to use solid tipped spark plugs not the screw on ones as they can cause some resistance.

Good Luck

:thumbsup:
 
1 - 2 of 2 Posts
Top