Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
9 Posts
Discussion Starter · #1 ·
I am ready to order a new top end kit Ebay. However, most of them are listed with standard size, 0.25mm over, 0.5mm over... etc. I am confused of what size to order. What is the advantage to go over size (.25mm or .5mm)? If I want to go over size, do I need to also bore the cylinders? Thanks
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.