Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just put new SBT engine in. Have two issues need help with. When I turned the shaft for the impeller I felt a little nickking when turned. Would rotate then nick. Also how do I go about adjusting the servo motor cables to the power valves. I can rotate the servo motor in both directions. Need procedure for final adjustment. At what position should the servo motor be before final cable adjustment. thanks.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top