Personal Water Craft Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 · (Edited)
STILL NEED HELP ANY IDEAS OUT THERE???
I have a 2000 Yamaha 1200xl limited edition waverunner with around 60 hours on it.
It cranks good cold and hot if you cut off and right back on.
If you get the waverunner hot and shut off for over 10 min then when you pull the throttle lever it sticks wide open. If you let the unit sit for say 4 hours it works fine.

ANY IDEAS??????
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #4 ·
If you let sit more then 15 min the throttle sticks wide open and you have to choke to get cranked and run a few min to get throttle to operate properly. I just don't understand the throttle sticking if you let sit for 15 min but not if you crank right back up or let sit overnight.
Does your throttle stick wide open??????
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #6 ·
Thats the problem. It seems to be in the round assembly the cables hook to or on the cable that pulls it back. I have greased all the cables and no results. I guess the next step is to try to pull the round assembly that the cables hook to off. It seems something is heating up and when it cools off some it sticks. If cold ok or if you keep hot it is ok.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #8 ·
I got the service manual disk off of E-BAY for around $9.00 but I haven't had a chance to check out yet.

I'm hoping ""SOMEBODY OUT THERE"" has already fixed and will tell both of us before I have to tear into it.
 
1 - 4 of 4 Posts
Top