Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Was wondering if anybody could help.
I replaced the battery on my seadoo gtx and by mistake connected the poles opposite. after realising and correcting it tried to start it and when i connect the key there is no beeping and nothing comes on the control panel. i checked the fuses and they are all ok. i checked if there was power coming from the battery and there is. what else could have gone wrong. would appreciate any help..
thanx
 

·
Registered
Joined
·
9 Posts
What I've been told is you have to have the correct lanyard to even get the instrument panel to come on. Did you fry your DESS moduale by reversing the polarity? I can't get mine to start either but my fuel pump primes and the instruments come on...but no start...
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
found the fault

could'nt figure out what the prob was so decided to replace the fuses even if they were all fine. pluged the lanyard in and everything 100%.
must've had some corrosion on the contacts.
thanx for the help anyways
 
1 - 3 of 3 Posts
Top