Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2001 Polaris Virage 750 with the single Kehien carb. It ran well all last summer then it died. I rebuilt the carb and it still will idle, but will not rev up in the water. Out of water, the engine revs fine. Since I rebuilt the carb, I do not know where to start? Anybody rebuild these carbs anymore? I'm located in south central MICHIGAN.
 

·
Super Moderator
Joined
·
5,047 Posts
They are a simple carb. Where did you get the kit ? Did you replace the needle spring ? Did you pull the mixture screws, and if so, did you put them back to precisely the setting they were before ? Did you check the pop off ?
 

·
Registered
Joined
·
1 Posts
Did you resolve the Virage not going in the water but idling fine? I have a Freedom doing the same thing. Even revs on the trailer fine, like yours.
 
1 - 3 of 3 Posts
Top