Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
The ski will start just fine when you press the button ,but when you want to cut the engine the only way is to pull the laniard . If you push the button to stop you will run over what ever is in front of you . If someone has a little knowledge of the start/ stop circuit would be a big help
thanks joe
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.