Personal Water Craft Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Happy New Year everyone! I just pulled my pump on my aquatrax during the winter season to try and see why my holeshot is so bad. This is what i found on the impeller:
18380
18381

I checked my wear ring tolerance and was within the specs per the Aquatrax Service Manual (0.02 in). What should i do with this impeller? Is it even fixable? Could i spot weld in those divots and file it smooth and run it okay? Thanks in advance!
 
1 - 1 of 1 Posts
Top