Personal Water Craft Forum banner
1 - 7 of 7 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
My sister bought a used jet ski. It has only 6 hours on it and had been sitting a while. When they went to look at it, the previous owner enabled with key fob and tried to crank but the battery was too low. My brother in law replaced both the keyfob and ski battery. The key fob doesn't seem to do anything. When pressing start button the guage activates, warning light comes on then off, and the electronics appears to enable but there's no clicking or attempt to turn over. Does the key fob need programming to the ski? Does this ski have a security code that needs to be entered or reset? Thanks in advance.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.