Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have a 91 650 SX and need to remove pump and impellar assembly...any tricks? Do i just remove the 4 bolts that hold pump? I know the impellar comes out with pump....does it just slide off the shaft with the entire assembly?

any help is appreciated.

Kevin
 

·
Registered
Joined
·
144 Posts
Yes it just slides out the back. It's a bit of a pain to do though. Cut as much of the silicone caulking away as possible before trying to gently pry the pump housing away from the hull.

Hold the driveshaft to keep it engaged with the engine while sliding the pump back or you could damage the seals at the through hull assembly.

Hope this helps
 
1 - 2 of 2 Posts
Top