Personal Water Craft Forum banner
1 - 3 of 3 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Hello all-I am new to this forum and to the pwc world and had a question. Is it possible to put a flush out kit on a 1991 650 vxr? I don't see any factory flush out fittings and i don't like the idea of not being able to flush out the engine after each use. If so where does it get installed at? Any and all answers will be greatly appreciated. Thanks Bob
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.