Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
the ski ran great the last time i used it but when i went out last week it started up but was bouncing off a low rev limiter. its the 701 61x motor. the only thing i tried was unhooking the overheat sensor from the electrical box but its still doing it. what else would cause it to run in limp mode? it starts right up and idles great. please need help. thanks.
 

·
Registered
Joined
·
7 Posts
Did you ever figure this out. Mine does this too, but when I disconnected the pulse wire(red/white) it starts revving fine.
 
1 - 2 of 2 Posts
Top