Personal Water Craft Forum banner
1 - 2 of 2 Posts

7 Posts
Discussion Starter · #1 ·
I just pulled my jetski out of storage it hasn't ran in 2 years because I was finishing my MBA.

I just drained the gas tank and put new fuel in Changed the spark plugs and put all new gaskets and springs in the carburetter.

I set the carb back to the factory settings. Low 1-1/16 High 15/16 Pilot 1-5/16.

I don't have a choke but have a primer. When I give the primer a couple of pumps it fires up like a champ but will only run for half of a second with tons of smoke.

The compression is at 124 in each cylinder.

What should I do now?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.