Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hey everyone,

I just bought an 89 650 sx when i bought it it ran fine put it in the water ran good but bogged at high rpm's thought it would be the high end tune on the carb tried messing with that and no change checked the spark plug and my #2 cyclinder was not firing (spark plug wet after running) #1 cyclinder bone dry. change the plugs ran the same and now it just wont start and is not getting and spark. I don't know if its the coil pack (ignighter) or the voltage regulartor. anyone got any input on my lovely problem? please let me know and thanks in adavnced.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.