Personal Water Craft Forum banner
1 - 4 of 4 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
hi all, me and a mate recently aquired a 900zxi, unsure of the year.

It runs out of the water fine (i know its not good to run them out of water for too long because of cooling etc, so we didnt run it for long) the only problem out of the water is that it cuts out at idle. but when in the water it doesnt rev properly and when it gets to 4000 rpm, the max it will go in the water it just potters along slowly and makes loads of noise. when you lift the seat there is loads of steam/smoke. there is a small amount of water in there but nothing that wasnt there before. we are running it premix as the oil pump has been removed.
any help much appreciated.

and also the trim isnt working.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.