Fresh bore on motor new carb rebuild all stock except the bore what should it top out at mph? Bought this 4 months ago guy told me ran great! Yeah on the trailer cylinder #1 90pounds Cylinder#2 90 cylinder#3 40 pounds! My fault I didn't do compression test. So all buyers beware before you buy!
900 zxi
1 - 3 of 3 Posts
Joined
·
18 Posts
i have a 95 and i get it up to 54mph
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
2008 STX-15F overheating issue
Kawasaki JetskiGreetings All, I am having a strange issue with my 2008 Kawasaki STX-15F Jetski; when I go to run it in the morning; it runs great, and there is water coming out of the cooling port; after running it for about 1/2 - 1 hr, and run at idle, like I would do to dock it, steaming hot water spits out...- 1
- 2K
-
2005 stx1500 kawasaki jet ski ski will only go to 5200 rpm
Kawasaki JetskiHello all: I have wrote a few post on this subject. I have some new thoughts on this. I have now replaced every input signal device that the ski has with the exception of TP sensor, but have metered it out and it says it good, replaced all injectors, all fuel lines and filter. Also stupid I...- 0
- 315
-
Ultra 150 oil injection system
Kawasaki JetskiI have an 2000 Ultra 150, I assume same motor as 2000 STX. I always premix about an ounce of oil to the gallon in addition to the what is provided by the oil pump, just for insurance when running at high rpm, because I understand the pump to be variable with speed but I worry about it providing...- 1
- 180
-
750 exhausts
Kawasaki JetskiI am trying to get a green/big pin 750 engine going in a Sport Cruiser... I previously had small pin installed but blew it up. Trying to sort out the exhaust and need some help. I just purchased a green 750 exhaust manifold on ebay and when I got it home realized the opening to the head tube is...- 3
- 150
-
nichdiep · updated
-
2000 kawasaki 1100 stx di oil flooding cylinders
Kawasaki JetskiMy dad bought his PwC brand new and right now it's only got 15hrs on it. He parked it years ago because when you try to crank it, the plugs foul out because the cylinders get flooded with oil and then it wont even spin over. To get it to spin over again, you have to pull the plugs and get the...- 11
- 560
Join now to ask and comment!