Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I recently purchased a 93 XP. Needed a new starter. Put a new one on and ran perfect. Put it in the river today and went on a ride. Brought it back and tied it up to the dock. Few hours went by and has a good amount of water in it. Took it out of water and filled it up with water and tilted it on its side. A steady stream of water came out of about 3 rivets towards the very back that hold on the bumper strip. It didn’t seem like they go all the way through to the hull but they must. So does anyone know what I should do to seal these up or replace them? Thanks
 
1 - 1 of 1 Posts
Top