Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Looking for some help figuring out what caused this engine to fail. My buddy gave me the ski when it abruptly stopped running. Turns out it threw a rod. I took the head apart and I can tell it was hot when it failed. Definitely some pitting on the pistons, etc.

I'd like to put a new motor in it but I don't want to blow up a new motor the same way the old one died. Any ideas what might cause it to throw a rod? The cylinder walls looked good and it appeared to be running fine until it died.

OH, and would I get an extra charge for the thrown rod by SBT? I know they charge for certain damages.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top