Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I think my machine got a little frost one night before I winterized it. When I took the water inlet tube off the pump to run anti-freeze through, I noticed antifreeze sitting in the bottom of the boat. If it did get a freeze, where are typical cracking/blow-out spots?

I believe its a 580, or close to. Are there frost plugs? or certain gasgets that blow out?

I did start up fine, but Im really worried.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.