Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I just purchased a 95 SLT 750 and it won't go over about 10 MPH. It seems to start up, idle, and run fine to a point, but has very little power.

Here are some other clues.

The display flashes LOPr even though the oil tank is full. I believe that is a low oil indicator.

The Fuel and Oil bars on the sides of the display shows both are empty even though the gas tank and oil tank are both full.

Does anyone know how the oil and fuel senders work on this model? Is there a way to temporarily bypass the low oil sensor to see if that is the cause?

Does anyone have information on how the display works for this model? I didn't get an owners manual.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Plugs were the main culpret

I changed the plugs and it runs quite a bit better. It was not in limp mode after all.

It still idles a little rough and doesn't have much power in the mid range. Once it gets over 4,000 RPMs it smooths out and flies.

I'm going to look at replacing the plug wires and eventually do the 3 port fuel pump upgrade. It still has the original single port fuel pump on it.
 
1 - 2 of 2 Posts
Top