Personal Water Craft Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
i have a 95 slt 750 and one of the pistons melted and got a hole in it when somebody was riding and a plug wire came off and it got hot from running on the two cylinders. well now im looking at getting sbt to do there cylinder replacment for me. should i bore it out? and if i do what jet sizes do i need and is there anything else i should know about while im doing this. thanks guys for any help.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top