Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
I know you cleaned the carbs but did you adjust the float setting????

if the float level is too low it would run great 'till the fuel demand over ran fuel availability in the bowl......

that is the only thing I can think of other than a partially plugged fuel filter.....did you check for an inline filter???

oh..... one other thing...... you could have a air leak!!! with the ski running spray starting fluid very lightly around all potential areas for an air leak!!!....could be a gasket, o-ring, but be careful carb cleaner is very corrosive to rubber!!!

if the engine revs higher you know it is sucking starting fluid!!!! great way to narrow down the area it might be.....

post your results and I will try to help!!! feel free to PM me
 
1 - 1 of 1 Posts
Top