Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have a 96 Sea Doo GTX where the engine and drive shaft are out.

The collar on the drive shaft has been removed.

I am trying to reassemble the drive shaft in preparation for the motor.

I have a rubber boot (I know which way that is installed) along with the drive shaft, a steel collar, and a black collar and I need to know the proper orientation of those items.

I have the shop manual but it is not clear.

Can anyone help?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.