Personal Water Craft Forum banner
1 - 4 of 4 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I need to replace the starter on this machine but I don't have a schematic or service manual for it. I looked on your site for a downloadable manual but couldn't find one. Not sure I even need one, but, here's where I am now. I removed the two 10mm bolts and the + and - connections from the old starter, but can't seem to pull it out. The machine has been sitting for about 3 years. Should I be removing anything else first, or should the starter pull out after what I've just done? I know not to jiggle or pry the unit for fear of breaking the shaft or damaging the flywheel. Any help will be appreciated.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.