Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I Replaced The Motor Mounts In My 96 Montego Dlx.my Problem Is Ligning Up The Engine Coupler Half To The Couplre Half On Drive Shaft.i Dont Have The Proper Tool ,anyone Have Suggestion.i've Fought With This For Hours,yet I Cant Get Proper Alignment.book Says,leave Out The Rubber Part Till Alignment Is Achieved,then Slide Engine Forward,install The Rubber Part,slide Engine Back In Place.yeah Right,for Some Reason,i Havent Been Able 2 Do This. This Is A Very Nice Ski,i've Owned It Over 5 Years,has Never Had A Break Down,when I Get The Engine Ligned Up,it Will Be For Sale,i Have Several Nice,some Like New,tiger Shark Montegos,95-97,if Anyone Is Interrested.i Also Have Tons Of New Parts For Several Models Of Tiger Sharks. Lots Of New Gaskets.
 

·
Registered
Joined
·
61 Posts
The easiest way to achieve this is with an engine hoist, otherwise, your trying to hold the engine and move it at the same time. Do you have one? Also, can you PM me more info on your other skis and maybe some pictures??
 
1 - 2 of 2 Posts
Top