My 96 polaris slt 700 was running great, really awsome. Until took it out and it will barely run. When it does run it doesnt have very high rpms. Its getting spark and fuel. Sounds like it is backfiring or missing a little bit. Only thing i did was take the oil pump off to tighten the bottom. Now it does this.
96 SLT 700 Problems
1 - 4 of 4 Posts
Bummer
Took a look at the oil pump and it had cracked and broke a pieace off. Did compression test with no psi in mag cylinder, so tore it apart to see the ring fried and cylinder wall scarred. Has good 110 psi in other cylinder. Anyone think i should replace both?
Took a look at the oil pump and it had cracked and broke a pieace off. Did compression test with no psi in mag cylinder, so tore it apart to see the ring fried and cylinder wall scarred. Has good 110 psi in other cylinder. Anyone think i should replace both?
110 psi is NOT that great - I would at least check out the other cyl./piston to make sure you don't have any scoring on it. If it were mine - I would replace both.
I took the other one apart and it was fine. But am going to do total top end rebuild.
1 - 4 of 4 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Top Contributors this Month
View All
BillyGP1200
2 Replies
bobkeogh89
2 Replies
figulaxde55
2 Replies
Recommended Communities
Join now to ask and comment!
