Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
I have a 96 wave venture 1100 that i am replacing the engine on. I have removed the intake and exhaust manifolds and ready to remove mounts to get engine out. Im using a guide someone suggested from shop sbt, but it doesnt mention anything about removing what looks like to me the coil pack and The pcm or computer that has many wires connected to it. It doesnt look like plugs that i can just disconnect and this is my first time working on one of these, so i was hoping someone could help me, it would be greatly appreciated.

I just need to figure out how to get the wiring off of this so i can pull the motor out. There are plates holding the harnesses in place, if i remove these plates will i be able to just unplug these wires?
Thanks in advance!
 
1 - 2 of 2 Posts
Top