Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey guys/gals, doin a swap on my 760 WB2. Cyl1 starved the crank and destroyed all kinds of crap. so..out with the junk, and in with something different. i picked up a good used 650 pretty cheap. Was wandering what all imma run into when dropping it in place of the 760.. any info? i realize it'll be slower, but thats ok, atleast it'll get me back out on the water. imma run it on PRE-MIX this time to prevent oil pump failure like last time..lol..crap! Any pointers on jetting n such would be great! All info is GREATLY appreciated! Thanks folks!

-Zac
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
its in and runs...

Motor is in, and runs good so far?.. need to get it out on the water to verify that for sure. there were a few complications i ran into, but nothing i couldnt solve. Thanks for reading..
 
1 - 2 of 2 Posts
Top