Personal Water Craft Forum banner

97 Tigershark 770 wire harness advice

1K views 0 replies 1 participant last post by  11sw03 
#1 ·
I recently started work on a 1997 Arctic cat Tigershark 770. I had to do some work on the engine, so I removed the guts to the electrical to get better access. However I forgot to take pictures of which wires plug back into which. I managed to get almost all the wires with matching plugs and wire colors however I’m left with two plugs left. They both fit into each other however I know they don’t go together because 1. The colors don’t match
2. One plug only has 3 wires to it and the other has 4
3. When I plug them together the motor still doesn’t start
I’m honestly at a loss here. I’ve looked all over for where these might go but I can’t find anywhere. If anyone knows anything I would really appreciate it.
Below are pictures of the 2 wires in question
 

Attachments

See less See more
5
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top