Personal Water Craft Forum banner
1 - 3 of 3 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
New to Jet Skis :) I am in the middle of a rebuild on a 1200- 65M engine and the crank case area were the head attachs looks like missing material? can this be fixed with some JB weld or?
Also when doing assmebly what is best Lub to use for crank bearings and do you use any gasket sealant or just use gaskets plain for assembly?
Any other comments also much appricated



1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.