Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello, I have a 98 Seadoo XP Ltd, and when I put it in the water today, it starts and revs fine but there is little to no propulsion (just enough to get me out a bit and back to shore, and round a little to see if it corrected itself). Can anyone shed some light on this for me.

I have looked into the impeller housing, and it looks clear, and the impeller is rotating without resistance??

Any and all help is appreciated.

Regards
CelticSki
 

·
Registered
Joined
·
25 Posts
There are two possibilities. For the first get a good flashlight and inspect the wear ring and impeller by looking through the intake grate. This sounds like you may have a damaged wear ring or impeller. As for the second possibility you said the impeller is rotating without resistance, is this with it installed on the boat? If so you may have stripped the PTO or impeller shaft splines.
 
1 - 3 of 3 Posts
Top