Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have taken off the carb shell, the screen and the metal plate. Now I'm stuck, I can't figure out how to remove the carbs. My goal is to clean the screens and clean out the carbs, the first one (bow side) is easy because it faces out, after that I can't figure out how to remove the shell of the first carb to be able to access the intakes of the second and third carbs. Any help would be appreciated. :thumbsup:
 

·
Registered
Joined
·
7 Posts
the carbs come out on one rack. you have to remove the air box 5mm alans, and you should have 6 or so 12mm nuts on the rack foot, after removing all the lines(fuel&oil and pulse) the rack should slide over the studs. note :you have to use a stub 12mm to fit in the hull.
rob
 
1 - 2 of 2 Posts
Top