Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a 2003 Yamaha gp1300r… today I started to experience acceleration problems..
When I slam the throttle from a stop it just revs the hell out of it and it doesn’t move…
I need to slowly gain speed and once I am moving I can then hit the gas hard and it will go…


What might the problem be?:dunno:
 

·
Registered
Joined
·
23 Posts
My WR III started doing that...

I pulled it out of the water..pulled the inlet grill off the bottom and saw that the leading edges of the impeller had been mushroomed (last tyme i let my aunt borrow it)..

I took a course then fine file to it (carefully so not to hurt the housing) and cleaned up the edges..

This immedietaly fixed the "over-rev..under-accel" condition i had..

And only took a min or two..per blade

Might be something you can try..
 
1 - 2 of 2 Posts
Top