Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,033 Posts
Did you reset the start code? If the battery was disconnected I think you have to put in "AAAA" or reset the code you were using. Sure you have a good battery?

Does it turn over and just not start, or nothing? Any clicks when you hit the starter?
 

·
Registered
Joined
·
3,033 Posts
Yea I'd try reseting the lock code first just to be sure. I think you disconnect a blue connector behind the front storage compartment then hold down the mode button and enter a new code when it tells you. Enter the new code and it should say "Start" again.

Next I'd check and clean all wire connections (tight and no corrosion) from battery on. Open the electronic box and make sure the wires going to the starter solenoid are tight and not corroded (May be a brown wire). Also check fuses.

Be sure you didn't suck something into the pump that is keeping it from turning over. Look in the intake grate, and remove if necessary to be sure all is clear. Pull the plugs and be sure you can turn the engine over by hand (be sure to pull the lanyard when you do this).

If you try the above and still no luck, I'd test the starter solenoid next then the starter.
 
1 - 2 of 2 Posts
Top