Personal Water Craft Forum banner

Australian tigershark parts needed

Jump to Latest Follow

1 - 4 of 4 Posts
L

·
Registered
Joined
·
3 Posts
Discussion Starter • #1 •
Have a 1998 ts1000r in Australia, need 3 new cylinder barrels as the skirts broke off on removal. Also need new crank. This was a pwc I bought in siezed status...but did not expect it to be soooo... siezed up.
Any parts available would help
Complete engines??
 
1 - 4 of 4 Posts
Recommended Reading
Read More

  1. Help, PWC dies while in idle/ high throttle

    Tigershark Jetski
    Hi, I am new to the jet ski community and need some general advice/ guidance. I have recently acquired an aftermarket 97 Tiger shark 770 and am having some running issues. It has a new engine with about 8-10 hours on it at the time of purchase. The owner had tore out the oil injector and added a...

  2. fuel return question

    Tigershark Jetski
    Im putting a motor and jet drive from a 96 Tigershark 640 in a small aluminum boat, my plan was to use a small gas tank but it only has an outlet, what do I need to do with the return line from the carb? Also can I delete the oil injection and just mix the gas and oil?

  3. 95 Monte Carlo intermittent spark

    Tigershark Jetski
    My ski has an issue with spark. It seems to have spark on and off. Does it mean the ignition coil needs replacing? Could there be something else causing this intermittent spark issue?

  5. 96 motego dlx questions

    Tigershark Jetski
    Looking into getting a good running montego dlx 2 strk. Everyone under the sun says parts are impossible to find and if ot breaks im sol, but everything i read on the internet makes it sound like its gonna be one of the best cheap skis i could get. Whats the truth? Where do i source parts from?

  6. tigershark 640 monte carlo..whats wrong?

    Tigershark Jetski
    i have two tigershark 640 monte carlo's one is great and alot of fun. tyhe other runs but is slow to respond to the throttle and dosnt have any power...today i pulled the plug that reveals the timing marks on the flywheel...when runnning there is comppresson and vacume from that plug...my other...
Read More
About this Discussion
3 Replies
2 Participants
Last post:
JUST-IN-TIME
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Explore Our Forums
Yamaha Jetski General PWC & Jetski Discussion Kawasaki Jetski Sea-Doo Jetski PWC Jetski Classifieds
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Top